![background image](http://html2.mh-extra.com/html/yaesu/ft1dr/ft1dr_operating-manual_3152714088.webp)
88
Communicating with a Specific Remote Station
Using the Tone Squelch Function
Notification of Call from the Remote Station by
Vibration of the Vibrator
Set the vibrator to alert you of a call from a remote station containing a corresponding
CTCSS tone or DCS code.
Enter the Set mode:
1
Press and hold
M
over 1 second.
2
Turn
O
to select [8 CONFIG].
3
Press
H
.
4
Turn
O
to select [22 VIBRATOR].
5
Press
H
.
6
Turn
O
to select [MODE].
7
Press
H
.
8
Turn
O
to select [SIGNALING].
9
Press
p
to set the Vibrator mode and exit the Set mode.
Tip
To turn off the Vibrator function, select [OFF] in step 7.
Tips
• The vibrator function can be set for all frequency bands belonging to A-band (Main) and B-band
(Sub).
• Selecting [8 CONFIG] [22 VIBRATOR] [MODE] and
then [BUSY] for [MODE] in the Set mode will cause the vibrator to
start vibrating when the BUSY LED lights upon reception of a
signal.
• If the BUSY state is not held continuously over 5 seconds, the
suspended state is canceled.
If the
p
switch is operated to change the communication mode from transmission to reception
when the vibrator is turned ON, the vibrator function is turned off for 5 seconds.
Selecting Vibrator Operation Mode
Enter the Set mode:
1
Press and hold
M
over 1 second.
2
Turn
O
to select [8 CONFIG].
3
Press
H
.
4
Turn
O
to select [22 VIBRATOR].
5
Press
H
.
FT1DR̲DE̲Eng.indb 88
FT1DR̲DE̲Eng.indb 88
13/06/28 15:16
13/06/28 15:16