37
Basic Operation
Miscellaneous Settings
Adjusting the Squelch Level
You can mute the raspy noise heard when no signal is being received. The squelch level
can be adjusted separately for two broadcasts (FM and AM) received on the A-band and
B-band. When the squelch level is increased, the noise is more liable to disappear but, if
it is set too high, it becomes difficult to receive weak signals. Adjust the squelch level as
required.
1
Press
A
to select the desired operating band.
2
On the FT1DR, press
F
and then
T
.
On the FT1DE, press and hold
M
over 1 second to enter the Set mode, and then
select [4 SIGNALING] [8 SQL LEVEL].
3
Turn
O
to adjust the squelch level.
Remark
The squelch level can be adjusted within the range from 0 to 15.
Default: LEVEL 1
4
Press
p
to save the Squelch Level Adjustment and exit
the Squelch Level Adjustment mode.
Tips
While
T
is held pressed, the squelch function will be deactivated
for both the A-band and B-band.
Changing the Frequency Step Manually
By default, “AUTO (Step)” is selected so that the optimum frequency step is
automatically selected according to the received frequency. You can change this
frequency step manually.
1
Press and hold
M
over 1 second.
Enters the Set mode.
2
Turn
O
to select [8 CONFIG].
3
Press
H
.
4
Turn
O
to select [18 STEP].
5
Press
H
.
6
Turn
O
to select your desired frequency step.
Remark
Selectable frequency steps are as follows:
• AUTO
• 5 KHz
• 6.25 KHz
• (8.33 KHz)
• 10 KHz
• 12.5 KHz
• 15 KHz
• 20 KHz
• 25 KHz
• 50 KHz
• 100KHz
It is recommended that AUTO be selected normally.
Default:
AUTO
7
Press
p
to save the frequency step, and exit the Frequency Step Setting mode.
FT1DR̲DE̲Eng.indb 37
FT1DR̲DE̲Eng.indb 37
13/06/28 15:16
13/06/28 15:16