•
Backflow Consecutive Intervals
: Will be one of the following valid values: 1, 2, 12, or
24.
•
Broken Pipe Threshold
: Will be one of the following valid values: Disabled, 500 Counts,
800 Counts, 1350 Counts, or 4500 Counts.
Electric-Specific Parameters
Note
:
The following parameters are the default settings that, if unchanged, are programmed into
the SmartPoint. They can be changed on the HHD (if necessary).
•
Frequency
: Indicates the assigned frequency your utility is to be using. Warning: If you
are not sure of this, please contact SENSUS Technical Services. If the Setup FlexNet
Radio check box is not checked, then the frequency will not be set during programming.
•
Setup FlexNet Radio
: Reconfigures both the frequency (selected above) and the RF
parameters in the SmartPoint. The RF parameters are set to the following default values:
•
Meter Sample Rate
: 1 hour
•
Supervisory Transmit Rate
: 4 hours
•
Buddy/Normal Transmit Sequence
: 1:8
•
Update Lat/Lon
: Updates the latitude and longitude in the SmartPoint with the acquired
value from the GPS connected to FlexPro.
Note
:
If neither
Setup FlexNet Radio
nor
Update Lat/Lon
is checked, then the installation
sequence will essentially perform an audit of the parameters that currently exist on the
SmartPoint. This can be useful for verification purposes.
RGS-Specific Parameters
Note
:
The following parameters are the default settings that, if unchanged, are programmed into
the SmartPoint. They can be changed on the HHD (if necessary).
3 Polling Devices | 37
