Xtralis HeiTel CamDisc HNVR, Product Manual

Page: 58 / 68

CamDisc HNVR Product Guide HeiTel by Xtralis
58 26419_04
Continuous recording For all video inputs:
Use easy mode=activated; Record image every=1 second;
Preset for non-easy mode:
Contact status Closed:
Rec. method/trigger=Off; Recording interval (s)=1; Number of images=1
Contact status Opening (Edge +):
Rec. method/trigger = Off; Recording interval (s)=1; Number of images=1
Contact status Open:
Rec. method/trigger=Permanent; Recording interval (s)=1;
Number of images=1
Contact status Closing (Edge –):
Rec. method/trigger=Off; Recording interval (s)=1; Number of images=10
General Settings Part 2/3
Audio Listening=activated; Microphone=activated; Line=not activated;
Speaking=activated
Relay Relay 1:
Name=Relay 1; Mode=Latch; Closed while idle=not activated;
Reset offline=activated;
Closed=10 s Relay 2:
Name=Relay 2;
Mode=Latch; Closed while idle=not activated;
Reset offline=activated; Closed=10 s
Serial channel Baud rate=9600; Mode=8N1 (8 data bits, no parity, 1 stop bit);
Function = Transparent
EMA (IDS = intrusion detection system)
EMA Enabled=not activated; Port=6666;
Synchronise device time with EMA=not activated
Message to be sent Address=00 00 00 (not defined);
For all following line entries:
Event=Off; Camera=1
Message to be received Address=00 00 00 (not defined);
For all following line entries: Enabled=Off;
Camera=1; Preset=Off; Alarm=Off; Relay=Off;
Trigger event=Off
Extras
Logfile Last caller=not activated; Change of inputs=not activated;
Only when armed=not activated; Temperature=activated;
Video signal loss detection=not activated;
Service Alarm call in case off reboot=not activated;
Alarm call in case of defective Hard Disk=activated;
Routine call every 24 hours=not activated (Time=12:0);
Extra Use without hard disk drive=not activated;
Hang-up and redial on alarm=not activated;
Release access for PTZ, Relay, Audio after [] seconds = 60;
Software video signal lost detection = Immediately