Xtralis HeiTel CamDisc HNVR, Product Manual

Page: 18 / 68

CamDisc HNVR Product Guide HeiTel by Xtralis
18 26419_04
3.7 Pin Assignment and Functionality
General
All terminals are pluggable. It is recommended to remove the screw type terminal for wiring, especially of the
terminal block. This makes wiring of incoming and outgoing lines more convenient. The screw type terminals
are grouped by functionality.
3.7.1 34 Pin Terminal Block
Pin Labeling/description Type Function
1 RS-485– Serial (D–) Use this terminal to connect up to 10 remote control
cameras or other compatible devices (e.g. matrix) with RS-
485/RS-422 interfaces.
2 RS-485+ Serial (D+)
3 Ground Common ground for RS-232 interface.
4 RS-232 Tx Serial TxD Use this terminal to connect 1 remote control camera or
one other compatible device (e.g. matrix) with RS-232
interface.
5 RS-232 Rx Serial RxD
6 Ground Common ground for all inputs of type "control input".
7 Al a/d Control input Arm/Disarm input for enabling/disabling dialup to a
CamControl receiver PC, controlled by "Control in", "Al in",
and "Motion Detection".
8 Aux in3 Control input Auxiliary input 3: Reserved.
9 Al in Control input Alarm input for dialup with automatic switching of video
input 1 (V1 in) to a CamControl receiver unit.
Note: The operation of this input always depends on
the status of arm/disarm input "Al a/d".
10 Aux in1 Control input Tamper input for dialup with automatic switching of video
input 1 (V1 in) to a CamControl receiver unit.
Note: The operation of this input is independent of the
status of the arm/disarm enable input "Al a/d".
11 to
15 Control in 1-5 Control input Camera control inputs for external contact triggered
recording and/or selective dialup to a CamControl receiver
unit for video inputs 1 to 5. These control inputs can be
used for event recording as well as for event optimised
permanent longterm recording.
16 Ground Common ground for all inputs of type "control input".
17 Ground Common ground for all inputs of type "control input".