Xtralis HeiTel CamDisc HNVR, Product Manual

Page: 12 / 68

CamDisc HNVR Product Guide HeiTel by Xtralis
12 26419_04
l
19" Mount Kit : 2RU installation kit for 19" mode mounting of up to two CamDisc HNVR devices also in
combination with devices of the SVR series.
l
CamMount Kit : Two-part mounting plate for installation including strain relief
Note: Refer to our current price list for the respective part numbers.
3.3 Warranty
HeiTel guarantees proper operability of devices and accessories in accordance with the General Terms and
Conditions. Not covered is damage caused by:
l
non-compliance with the instructions provided in this guide
l
inappropriate use, storage, or operation
l
changes to devices not authorised by HeiTel
l l
use of components or accessories not approved by HeiTel
l
opening the device housing, or any kind of inappropriate intervention
3.4 Mounting and Setting up
CamDisc HNVR is designed for use in specific ambient conditions. Conditions deviating from these can
cause damage to the device, or to the recorded data. Warranty will be voided in this case. Please maintain the
ambient conditions described below when using your CamDisc HNVR device.
3.4.1 General Safety Information
l
Make sure to carefully read and understand this guide before operating the device.
l
Do not expose the device to strong vibration or shock.
l
Avoid humidity or dust, extreme temperature fluctuations, or strong magnetic fields.
l
The operating temperature for CamDisc HNVR is b5°C and 40°C.
l
Provide sufficient ventilation. Do not block vents. Provide sufficient air circulation for cupboard
installations.
l
Never expose the device to direct sunlight. Keep it well away from other sources of heat (radiators, etc).
l
Installation orientation: vertical, horizontal, with a deviation of not more than ±5°.
l
It is essential that you maintain the required ambient conditions for outdoor installations. Protect the
device against atmospheric influence.
l
Always switch off CamDisc HNVR using the main power switch, before removing or inserting a hard
disk.
l
Wait at least 10 seconds after switching off the device before turning it on again.
l
Always use the original power supply unit with the respective cable. Use it only for the dedicated voltage.
Ensure that the cable is intact. Never use damaged cables.
l
Select an installation site protected against burglary and vandalism. Ensure unrestricted ventilation.
l
Make sure that specification limits are not exceeded when connecting external devices.
3.4.2 Electrical Safety
l
Always make sure that your hands are completely dry before touching CamDisc HNVR, the power supply
unit, cables, or sockets. Never touch these with wet hands.
l
Disconnect the device from the power supply by pulling at the plug, not at the cable. Never pull at the
cable.
l
If water or any other liquid enters the device, immediately disconnect the power supply. Have the device
checked by customer service.
l
The device contains no components that can be adjusted or repaired by the user. The device housing
must never be opened.
l
Only trained personnel may open the housing for installing HYBRID Card 4, PSTN Cards or ISDN Cards.
The instructions in the included guides must be observed.