Xtralis HeiTel CamDisc HNVR, Product Manual

Page: 23 / 68

HeiTel by Xtralis CamDisc HNVR Product Guide
26419_04 23
3. The interface is also prepared for serial remote control of certain CamDisc HNVR features. Please refer
to information on designated firmware versions. (Minimum requirement: firmware 1.76).
4. The interface makes it possible to connect the HeiTel CI Adapter, making 50 additonal control inputs
available (minimum requirement: Firmware 1.76).
Configuration
CamControl LITE or CamControl PRO software allows you to set important interface settings, such as
connection speed and number of data bits and stop bits. The hardware handshake lines RTS and CTS require
wiring for proper operation. The operating mode in question can be selected from a drop-down menu. Refer to
the respective software guide for more information.
Pin assignment of RS-232 interface
Connector end view / 9 pin Sub-D socket
Pin Type Function Code designation
1 - - -
2 Output Transmit Data TxD
3 Input Receive Data RxD
4 - - -
5 Ground Ground GND
6 - - -
7 Input Clear to Send CTS
8 Output Ready to Send RTS
9 - - -
3.7.5 Audio Connections CamDisc HNVR
With CamDisc HNVR devices, you always should use a 3.5 mm stereo jack for the audio connections Mic,
Line in and Line out. Please observe the following table for connection details.
Connections stereo jack
Input Pin 1 Pin 2 Pin 3
Mic signal no connection ground
Line in signal no connection ground
Line out signal no connection ground