Xtralis HeiTel CamDisc HNVR, Product Manual

Page: 22 / 68

CamDisc HNVR Product Guide HeiTel by Xtralis
22 26419_04
3.7.3 Ethernet and ISDN Interface
Ethernet interface:
l
ACT: Flashes at data transmissions
l
Link: Lights up when the network is connected correctly
Standard IP addresses as supplied:
l
Ethernet: 192.168.31.95
l
IP Camera: 192.168.32.95
ACT LINK
ACT LINK
DCD STATUS
Operating status of the ISDN connection when using the ISDN Card:
Normal operation
Display Meaning
DCD on /Status off Power-on phase
DCD off /Status off Operational (ISDN OK)
Dial procedure
Display Meaning
DCD on /Status on Connected
DCD off /Status blinking no ISDN (No Dialtone)
Error conditions
Display Meaning
DCD off /Status blinking Check connection
Check the installation of the ISDN Card
Connecting to the telephone line when using the PSTN Card:
Connection to the telephone line
RJ45 Pin Signal Meaning
a1 b1
4 a1 Telephone signal
5 b1 Telephone signal
3.7.4 Terminal Transp. data/control interface
Use
1. Transparent transmission of serial data between CamDisc HNVR and an interface unit. Data will be
transmitted unaltered between the devices.
2. In POS (Point of Sale) operation, the interface facilitates the receipt of serial transaction data, from cash
registers or ATM machines for example. These data are linked with corresponding video images.
(Minimum requirement: firmware 1.76).
When using the HeiTel POS/ATM Adapter, the connection is established via a TCP/IP network
connection.
Due to the technical design of the POS/ATM Adapter, it is only possible to display transaction data on
analogue video signals. No such display is available for IP cameras.