70
NetBIOS over IP Peer to Peer Printing
D7
Before You Start
1. Obtain the Print Driver for your workstation's operating system. Drivers are available on one of the
CD-ROMs that came with your Device. They are also typically available for downloading in self-
extracting Zip file format from the Internet at www.xerox.com.
2. Print
a
Settings List
as stated under the
Network Connectivity Tab
of this guide.
3. On the Settings List,
verify that "SMB" is enabled
. Also,
verify that TCP/IP is enabled
as one of
the supported protocols (NetBEUI may also be displayed). Verify that the
workgroup's default
name is Workgroup
,
or a valid, 15 character maximum, workgroup name. Also note the
Device's
SMB Host Name
(which assures the uniqueness of the Device's name within the Workgroup). To
enable "SMB," if required, follow the procedure stated under the Microsoft (NetBIOS over IP) item of
the NOS Selection menu, accessed from the
Network Connectivity Tab
of this guide. To modify the
name of the Workgroup, or Device's name (SMB Host name) within the workgroup, use your
workstation's Web browser to access the Internet Services (Web Pages) residing in the Device, as
described under the Configure SMB menu item, under the
Internet Services Tab
of this guide.
4. Make sure to configure the DNS/WINS Server(s) for NetBIOS name to IP address resolution. Then
provide the Device with the addresses of the Servers as stated in the
Configure TCP/IP Settings
procedure of the Internet Services section of this guide.
Windows 95/98/Me Workstation Print Driver Installation
Verify that the Correct Protocols and Services are installed in the workstation
1. At the Workstation's Desktop, right-click the
Network Neighborhood
icon ("My Network Places" in
Windows Me) and select
Properties
.
2. On
the
Configuration Tab
, verify that
Client for Microsoft Networks
is installed. If it is NOT, click
the
Add
button, select
Client
, select
Add
, select
Client for Microsoft Networks
, and click
OK
. If the
setup program fails to find the required files, you will have to click
Have Disk…
to load the client from
the Operating System installer disk for this workstation.
3. On
the
Configuration Tab
, verify that the TCP/IP protocol is installed. If it is NOT, click the
Add
button, select
Protocol
, select
Add
, select
TCP/IP Protocol
, and click
OK
. If the setup program fails
to find the required files, you will have to click
Have Disk…
to load the protocol from the Operating
System installer disk for this workstation.
Summary of Contents for WorkCentre 7228
Page 1: ...System Administrator s Guide WorkCentre 7228 7235 7245...
Page 300: ...701P46436...
