Xerox WorkCentre 7228, System Administrator Manual

Page: 283 / 300

283
7. Under the
NetWare
data label, determine if the
IPX Frame Type
is set for
Auto
sensing (the factory
default). Other selections include Ethernet II (used when running TCP/IP on your network), Ethernet
802.3 (used for NetWare versions up to 3.11), Ethernet 802.2 (the default for NetWare 3.12 and
later), and Ethernet SNAP (used on networks running TCP/IP and/or AppleTalk). If the Frame Type
is not set to
Auto
sensing, or to the specific frame type used by the Primary Server, configure the
Device with the correct Frame Type following the instructions supplied in the
Configure NetWare
Settings
procedure in the Internet Services section of this guide.
At the Windows workstation, perform these tasks:
1. At your 95/98/Me/NT workstation verify that the correct protocol and service is installed.
At the Desktop, right mouse click the Network Neighborhood icon ("My Network Places" in Windows
Me).
Left mouse click on
Properties
.
Click on the
Protocols Tab
(in Win. NT) or the
Configuration
Tab (in Win. 95/98/Me) to verify that
the
IPX/SPX Protocol
has been installed. It should appear in the displayed list.
Note: If the IPX/SPX Protocol has NOT been installed, click the
Add
button, select IPX/SPX Protocol
from the available list and click OK. If the setup program fails to find the required files, you will have
to click Have Disk... to load the protocol from the Operating System installer disk for this workstation.
Left mouse click on the
Services Tab
(in Win. NT) or the
Configuration Tab
(in Win. 95/98/Me) to
verify that the
Microsoft Client for NetWare
is installed.
Note: If the Microsoft Client for NetWare is NOT installed, click the Add button, select the Microsoft
Client Service (or Microsoft Network Service) for NetWare from the available list and click OK. If the
setup program fails to find the required files, you will have to click Have Disk... to load the service
from the Operating System installer disk for this workstation.