Xerox Phaser 6200B, Service Manual

Page: 6 / 386

iv Phaser 6200 Color Laser Printer - Service Manual
Power Safety Precautions
Power source
For 110 VAC printers, do not apply more than 140 volts RMS between the supply
conductors or between either supply conductor and ground. Use only the specified power
cord and connector. For 220 VAC printers, do not apply more than 264 volts RMS
between the supply conductors or between either supply conductor and ground. Use only
the specified power cord. This manual assumes that the reader is a qualified service
technician.
Warning: Plug the three-wire power cord (with grounding prong)
into a grounded AC outlet only. If necessary, contact a
licensed electrician to install a properly grounded outlet. If
the product loses its ground connection, contact with
conductive parts may cause an electrical shock.
Disconnecting Power
Warning: Turning the power off using the On/Off switch does not
completely de-engergize the printer. You must also
disconnect the printer power cord from the AC outlet.
Position the power cord so that it is easily accessible during
servicing so that you may power down the printer during
an emergency.
Disconnect the power plug by pulling the plug, not the cord. Disconnect the power cord in
the following cases:
■
if the power cord or plug is frayed or otherwise damaged,
■
if any liquid or foreign material is spilled into the case,
■
if the printer is exposed to any excess moisture,
■
if the printer is dropped or damaged,
■
if you suspect that the product needs servicing or repair,
■
whenever you clean the product.