Xerox Phaser 6200B, Service Manual

Page: 63 / 386

Error Messages and Codes 45
Misfeed at Tray 3 Jam T3
The printers front panel displays “Misfeed at Tray 3” indicating a paper misfeed has
occurred in the printer. Tray 3 is free of defects and correctly installed in the printer.
Any obstruction, media and debris has been removed from the paper path and there is
adequate paper in the paper tray. Printer power has been cycled and the error still
displays.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
Paper Pick Roller Kit, PL 14.4.3 "Paper Tray 3" on page 367
Paper Feed Roller Kit, PL 14.1.2 "Paper Feed" on page 362
HCF Paper Pick Assembly, PL 14.4.1
Troubleshooting Procedure Table
Steps Actions and Questions Yes No
1 Does the printer feed paper correctly from
Tray 1? Go to step [2]. See "Misfeed at
Tray 1 Jam T1"
on page 40.
2 Does the HCF Motor run when printing one
sheet? Go to step [10]. Go to step [3].
3 Use service diagnostics to test the HCF
Motor.
Does the HCF motor function correctly? Replace the
Engine Control
Board,
RRP 12.7. Go to step [4].
4 Verify the voltage between P/J84-3 <=>
P/J81-1 on the Lower Feeder Circuit Board is
+24 VDC Go to step [7]. Go to step [5].
5 Verify the voltage between P/J81-2 <=>
P/J81-1 on the Lower Feeder Circuit Board
HCF is +24 VDC. Replace the
Lower Feeder
Circuit Board,
PL 14.5.1. Go to step [6]
6 Verify the connector between the HCF and
the printer is connected properly and not
damaged. Replace the
damaged part. Go to step [7].
7 Does the error recur after the HCF Motor has
been replaced with a new one? Go to step [8]. Complete
8 Perform steps 1 through 3 in RRP 14.3. Open
and close the front door.
Observe the Turn Roller.
Dose the Turn Roller turn while the machine
is warming up? Go to step [12]. Go to step [9].
9 Does the Tray 3 Turn Clutch Assembly
function correctly when feeding 1 sheet of
paper? Go to step [14]. Go to step [10].