Xerox Phaser 6200B, Service Manual

Page: 80 / 386

62 Phaser 6200 Color Laser Printer - Service Manual
Tray [2] [3] Paper is Low
The printers front panel displays “Tray 2 or 3 Paper is Low” when the paper tray is
full of paper. The tray has been inspected for defects. Printer power has been cycled
and the error still appears
In the following procedures, diagnose the part that correlates directly to the Tray
receiving the error.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
Low Paper Sensor, PL 14.5.7 "Paper Tray 2" on page 366
Low Paper Lever, PL 14.5.8 "Paper Tray 3" on page 367
Troubleshooting Procedures Table
Steps Actions and Questions Yes No
1 Fill the tray with paper.
Does the error occur if the tray is full? Go to step [2]. Complete
2 Check the following for evidence of fault or
damage:
Low Paper Sensor; PL 14.5.7
Low Paper Lever, PL 14.5.8 Replace the parts
concerned Go to step [3].
3 Use service diagnostics to test the
Tray [2] [3] Low Paper Sensor.
Do the sensor and actuator function
properly? Replace the
Engine Control
Board,
RRP 12.7. Go to step [4].
4 Does the printer function correctly after
replacing the Circuit Board HCF? Complete Go to step [5].
5 Troubleshoot using the Paper Tray [2] [3]
wiring diagrams.
Does the printer function correctly after
replacing any defective parts? Complete Replace the
Engine Control
Board,
RRP 12.7.