Xerox Phaser 6200B, Service Manual

Page: 161 / 386

FRU Disassembly - Removal and Replacement Procedures 143
12. Remove the 8 short screws securing the Printer Chassis (item #1) to the Paper
Feeder Assembly (item #2).
Note: It is easy to strip the long screws, use caution when removing
and replacing.
13.
Using a PZ1 Posi bit, remove the 4 long screws securing the Printer Chassis to the
Paper Feeder Unit Assembly.
14. Using a large screwdriver handle, prop up the right side of the printer chassis in
order to clear the wiring harnesses in the following steps.
15. Shift the harness P/J24 (gray) from the square hole on the bottom plate.
16. Shift the harness P/J210 (yellow) and P/J47 (yellow/blue) through the square hole
on the bottom plate.
Caution: Lift the printer chassis unit off the Paper Feeder Assembly
by placing your hands into the front and back cavity of the
paper tray. The right and left sides of the printer chassis
are extremely sharp.
17. Remove the screwdriver, being careful not to pinch the wires, and lift the entire
printer chassis off the Paper Feeder Unit Assembly.
Replacement
1. Replace in reverse order of removal.
Note: When replacing the Printer Chassis check to make sure none
of the wiring harnesses between the Printer and Feeder Unit
are pinched.