Xerox Phaser 6200B, Service Manual

Page: 72 / 386

54 Phaser 6200 Color Laser Printer - Service Manual
Install or Lock [Y] [M] [C] [K] Toner Cartridge
The printer’s front panel displays “Install or Lock Yellow, Magenta, Cyan or Black
Toner Cartridge”. The corresponding toner cartridge is correctly seated, all shipping
tape has been removed and the cartridge is fully locked into position. Printer power
has been cycled and the error still appears.
Note: Follow this troubleshooting procedure using the Y, M, C or K
steps as appropriate for the color indicated by the front panel
error message.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
Toner Present Switch, PL 10.1.18 "Developer Section 1" on page 356
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Use service diagnostic to test the toner
present switch of the problem color.
Does the Toner Present Switch (YMCK)
function normally? Replace the Engine
Control Board,
RRP 12.7. Go to step [2].
2 Check the following for evidence of fault or
damage, replace the assembly if
defective:
Toner Present Switch (YMCK), PL 10.1.18
Toner Present Switch Connector (YMCK),
PL 10.1 Complete Go to step [3].
3 Replace the Motor Driver Board.
Does the error recur? Go to step [4]. Complete
4 Troubleshoot the problem color using the
wiring diagram in the "Developer Section
1" on page 356.
Replace any defective parts. Complete Replace the
Engine Control
Board, RRP 12.7.