Xerox Phaser 6200B, Service Manual

Page: 97 / 386

Error Messages and Codes 79
Non-Xerox Imaging Unit
Code 95:
A non-Xerox Imaging Unit has been detected in the printer
.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
"Laser Unit" on page 359
Troubleshooting Procedure Table
Steps Actions and Questions Yes No
1 Is the Imaging Unit the correct Xerox part
numbered Imaging Unit. Go to step [2]. Have customer
order the correct
consumable.
2 Check the Imaging Unit for defects or
possible damage. Replace the parts
concerned. Go to step [3].
3 Does replacing the Imaging Unit fix the
problem? Complete Go to step [4].
4 Verify the CRUM Harness is not damaged
or improperly connected. Go to step [4] Replace the Plate
Dispense Left,
PL 10.1.9.
5 Remove the left cover.
Check the Gear Slide and the Rack V for
damage or misalignment.
Is the Rack V out of alignment?
See RRP 10.1 for more information. Damage can occur
if the Gear and
Rack are not in the
proper position.
With Door C open,
push the Rack V up
as far as it can go
and then reinstall
the gear slide. Go to step [5].
6 Check the CRUM Harness for continuity.
J170 <=> J71. Go to step [4]. Replace CRUM
Harness
Assembly,
PL 10.1.15.