Xerox Phaser 6200B, Service Manual

Page: 78 / 386

60 Phaser 6200 Color Laser Printer - Service Manual
Insert Tray [2] [3] orTray [2] [3] Missing
The printer’s front panel displays “Insert Tray 2 or 3” or “Tray 2 or 3 is Missing”. The
corresponding tray cavity is free of debris and obstructions. The paper tray is free of
defects and properly inserted into the printer. Printer power has been cycled and the
message still appears.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
Paper Size Switch Assembly, PL 14.3.6 "Paper Tray 2" on page 366
"Paper Tray 3" on page 367
Troubleshooting Procedure Table
Steps Actions and Questions Yes No
1 Check the following for evidence of fault or
damage:
Paper Size Switch Tray [2] [3], PL 14.3.6
Actuators on the side of the Tray [2] [3] Replace the
parts concerned. Go to step [2].
2 Use service diagnostics to test the Tray [2]
[3] Paper Size Switches use the table below
for reference.
Do the switches function correctly? Replace Engine
Control Board,
RRP 12.7. Go to step [3].
3 Troubleshoot using the Paper Tray [2] [3]
wiring diagrams.
Does the printer function correctly after
replacing any defective parts? Complete Replace the
Engine Control
Board, RRP
12.7.
Paper Size Switches are indicated as SW1, SW2, and SW3 from the above one.
Paper Size Paper Size Switch
SW1 SW2 SW3
LEGAL14" ON ON ON
LEGAL13" ON ON OFF
EXECUTIVE ON OFF ON
B5 ON OFF OFF
A4 OFF ON ON
A OFF OFF ON
A5
(Used for reference only.
Supported by MPT only.) OFF ON ON
No Tray OFF OFF OFF