Xerox Phaser 6200B, Service Manual

Page: 84 / 386

66 Phaser 6200 Color Laser Printer - Service Manual
Load Tray [2] [3] with [size] [type]
The printer’s front panel displays “Load Tray 2 or 3...” with a specific size and/or
type of paper. The tray cavity is free from debris and obstructions. The paper tray is
free from defects, fully loaded with paper and all paper guides are seated securely
against the paper. Printer power has been cycled and the message still appears.
Note: This is a media SIZE mismatch error.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
Paper Size Switch Tray [2] [3] PL 14.3.6 "Paper Tray 2" on page 366 and "Paper Tray 3" on
page 367
Troublshooting Procedure Table
Steps Actions and Questions Yes No
1 Check the following for evidence of fault or
damage:
Paper Size Switch Tray [2] [3] PL 14.3.6
Tray [2] [3] PL 14.1.1 Replace the
parts concerned. Go to step [2].
2 Use service diagnostics to test the Tray [2]
[3] switches, using the table below for
reference.
Does the sensor and actuator function
properly? Replace the
Engine Control
Board, RRP
12.7. Go to step [3].
3 Does the printer function correctly after
replacing the HCF Circuit Board ? Complete Go to step [4].
4 Troubleshoot using the Paper Tray [2] [3]
wiring diagrams
Does the printer function correctly after
replacing any defective parts? Complete Replace the
Engine Control
Board,
RRP 12.7.
Paper Size Switches are indicated as SW1, SW2, and SW3.
Paper Size Paper Size Switch
SW1 SW2 SW3
LEGAL14" ON ON ON
LEGAL13" ON ON OFF
EXECUTIVE ON OFF ON
B5 ON OFF OFF
A4 OFF ON ON
A OFF OFF ON
A5 (Supported by MPT only.) OFF ON ON
No Tray OFF OFF OFF