Xerox Phaser 6200B, Service Manual

Page: 81 / 386

Error Messages and Codes 63
MPT Empty, Load Paper
The printer’s front panel displays “MPT Empty, Load Paper”, but the MPT has paper.
The MPT is securely attached to the printer and the guides are resting securely against
the both sides of the paper in the tray. Printer power has been cycled and the message
still appears.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
MPT No Paper Sensor, PL 6.1.4 "Paper Feed" on page 362
MPT Actuator , PL 6.1.37
Troubleshooting Procedure Table
Steps Actions and Questions Yes No
1 Fill the MPT with paper.
Does the error occur even if the MPT is
full? Go to step [2]. Complete
2 Check the following for evidence of fault
or damage:
MPT No Paper Sensor PL 6.1.4
MPT Actuator, PL 6.1.37 Replace the parts
concerned. Go to step [3].
3 Use service diagnostics, to test the MPT
No Paper Sensor.
Does the Sensor function correctly? Replace Engine
Control Board,
RRP 12.7. Go to step [4].
4 Replace the MPT No Paper Sensor.
Does the error recur after the MPT No
Paper Sensor was replaced? Go to step [5]. Complete
5 Troubleshoot using the wiring diagram
"Paper Feed" on page 362
Does the problem recur if any defective
parts are replaced. Complete Replace Engine
Control Board,
RRP 12.7.