PDL principles and procedures
Using LCDS Print Description Language
1-53
d. Click the file name DFAULT.JSL, then click [OK]. The
default JSL is displayed in the Text Editor window.
3. Using the default JSL as a base, enter any changes,
additional commands or parameters, and deletions that you
need to make in order to construct your new JSL.
NOTE: You should consider carefully the ID name that you
enter in the JDL or SYSTEM command (the first line of the
JSL), because this identifier determines the name of the JDL
file when your new JSL is compiled.
The JDL name must be one to six characters in length, not
including the extension (following the dot).
4. When you have completed entering all the desired
commands and parameters, select [Save As] from the File
menu on the Text Editor window menu bar. The Text Editor –
Save As window appears.
Figure 1-12. Save As window
Summary of Contents for Nuvera 100
