Xerox DocuColor 12/DCCS50, Service Manual

Page: 1261 / 1617

1/05
8d-119 DocuColor 12/DCCS50
REP 15.3.16, REP 15.3.17
Finisher/Sorter
Reissue
Replacement
1. Position the Stapler Assembly near the Slider Bracket.
2. Route the wire harness through the harness clip near the rear of the Stapler Assembly.
3. Install the screw to secure the green ground wire to the Stapler Assembly.
4. Reinstall the Stapler Assembly onto the Slider Bracket, making sure to slide the rear tab
of the Stapler Assembly into the cutout on the Slider Bracket.
5. Position the Stapler assembly to align with the scribe lines as observed during the
removal, and then use two screws to secure the Stapler Assembly to the Rail.
6. Reinstall the harness clip to the side of the Stapler Assembly.
7. Reconnect P/J 1092 to the Stapler Assembly.
8. Reinstall the Stapler Cover Assembly ( REP 15.3.3 ).
9. Check the Staple Position Adjustment ( ADJ 15.3.1 ).
REP 15.3.17 Stapler Position Sensors
Parts List on PL 18.18
Removal
WARNING
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Disconnect the Finisher from the Printer ( REP 15.3.1 ).
3. Remove the Stapler Cover ( REP 15.3.3 ).
4. Remove the Rear Lower Cover REP 15.3.15 .
5. Remove the Stapler Assembly ( REP 15.3.16 ).
6. Remove the Stacker Tray Assembly ( REP 15.2.2 ).
7. At the rear of the Finisher, prepare to remove the Stapler Position Sensors by rotating the
Stapler Position Motor Drive Belt as you slip the Belt off of the Drive Pulley.
8. Remove the Stapler Position Sensors ( Figure 1 ).
1. Disconnect the three connectors from the Stapler Sensors, and free the wire har-
nesses from the harness clip that is located on the Stapler Rail.
2. Remove two screws at the rear of the Finisher and two screws at the front of the Fin-
isher that secure the Stapler Rail to the Finisher frame, and remove the Rail.
3. Place the Stapler Rail on a flat work surface.
4. Remove the screw that secures the sensor bracket of the sensor you are changing.
Remove the Bracket along with the attached sensor.
5. Press in and release the Sensor latch that is securing the Sensor to the Bracket, and
remove the Sensor.