Xerox DocuColor 12/DCCS50, Service Manual

Page: 1241 / 1617

1/05
8d-99 DocuColor 12/DCCS50
REP 15.2.22, REP 15.2.23
Finisher/Sorter
Reissue
Figure 1 Remove the Compiler Cover Assembly
Replacement
1. Reinstall the Compiler Cover Assembly by first sliding the Stack Height Actuator and the
Pinch Rolls through the cutout in the Assembly.
2. Hook the two arms of the Compiler Cover Assembly over the Pinch Roll Shaft.
3. Slide the front Pinch Roll Bearing to the rear so the arms of the Compiler Cover Assembly
ride on the Bearing. Use the screw (1) to secure the Bearing to the Finisher frame.
4. Slide the rear Pinch Roll Bearing to the front so the arms of the Compiler Cover Assembly
ride on the Bearing. Use the screw (1) to secure the Bearing to the Finisher frame.
5. Insert the Lever on the shaft and secure with the screw (1).
6. Insert the Offset Lever into the Offset Cam and onto the Eject Pinch Roll Shaft. Use the E-
ring to secure the lever.
7. Raise and lower the Compiler Cover Assembly to make sure it moves freely, and the
Stack Height Actuator and Pinch Rolls also move freely.
8. Reinstall the Stacker Tray Assembly.
9. Reinstall the Rear Lower Cover.
10. Reinstall the Stapler Cover Assembly.
REP 15.2.23 Eject Pinch Roll Shaft Assembly
Parts List on PL 18.20
Removal
WARNING
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Remove the Stapler Cover Assembly ( REP 15.3.3 ).
3. Remove the Rear Lower Cover ( REP 15.3.15 ).
4. Remove the Compiler Cover Assembly ( REP 15.2.22 ).
5. Remove the Eject Pinch Roll Shaft Assembly ( Figure 1 ).
1. Remove the front and rear bearings from the Eject Pinch Roll Shaft.
2. Disconnect P/J1075 from the Stack Height Sensor.
3. Slide the Eject Pinch Roll Shaft Assembly to the rear and remove it from the Finisher.
Figure 1 Remove the Eject Pinch Roll Shaft Assembly
Replacement
1. Insert the rear of the Eject Pinch Roll Shaft Assembly into the bearing hole at the rear of
the Finisher.
2. Insert the front of the Eject Pinch Roll Shaft Assembly into the bearing hole at the rear of
the Finisher.
3. Reconnect P/J1075 to the Stack Height Sensor.