Xerox DocuColor 12/DCCS50, Service Manual

Page: 1165 / 1617

1/05
8d-23 DocuColor 12/DCCS50
11-193 Decurler Exit Sensor Static Jam RAP, 11-
Finisher/Sorter
Reissue
11-193 Decurler Exit Sensor Static Jam RAP
The Control Logic detected paper remained on the Decurler Exit Sensor.
Initial Actions
• Refer to BSD12.6 for the following procedure.
• Ensure that no paper is blocking the Decurler Exit sensor
• Ensure that P/J651 and P/J654 on the Decurler Control PWB, and P/J658 on the
Decurler Exit Sensor are connected before beginning this RAP.
Procedure
Enter dC330 012-145 Decurler Exit Sensor. Press Start . The display is H.
Y N
Go to Flag 9 , Flag 10 , and Flag 11 on BSD12.6 and check the harness for a short circuit.
If the harness is good, replace the Decurler Exit Sensor ( PL 18.6 ). If the problem contin-
ues, replace the Decurler PWB ( PL 18.6 ).
+5VDC is measured between P/J654 -2 and GND on the Decurler PWB.
Y N
Replace the Decurler Exit Sensor ( PL 18.6 ).
Check the Decurler Exit Sensor for intermittent operation. If the sensor is good, Replace the
Decurler PWB (
PL 18.6 ).
11-301 Mailbox Door Interlock Open RAP
Mailbox Door Interlock Open Failure. This status code is declared when the Mailbox Door Inter-
lock Switch is open.
Initial Actions
• Refer to BSD12.1 for the following procedure.
• Ensure that P/J1033 on the Finisher PWB, and P/J1018 on the Mailbox Door Interlock
Switch are connected before beginning this RAP.
• Check the Front Door for proper alignment.
• Verify that the Front Door closes properly.
Procedure
Enter dC330 012-301 Mailbox Door Intlk Sw. The state of the Mailbox Door Interlock
Switch is Low and switches to High when the Mailbox Door is opened.
Y
N
With the Front Cover closed, there is +0 VDC between
P/J1033 -1 on the Finisher
and GND.
Y
N
Go to the Flag 1 and Flag 2 on BSD12.1. Check the wires for an open circuit. If the
wires are good, replace the Mailbox Door Interlock Switch ( PL 18.11 ). If the problem
continues, replace the Finisher PWB ( PL 18.4 ).
Check the Mailbox Door Interlock Switch for intermittent operation. Ensure that the switch
and the cover are properly aligned and adjusted. If the problem continues, replace the
Finisher PWB (
PL 18.4 ).
Check the Mailbox Door Interlock Switch for intermittent operation. Ensure that the switch and
the cover are properly aligned and adjusted. If the problem continues, replace the Finisher
PWB (
PL 18.4 ).