Xante Accel-a-Writer 3 Series, User Manual

Page: 112 / 320

4-24 PC Setup bb __________________________________________
9. Click OK. The Printer Properties window closes.
10. Select File: Close. The Printers window closes.
After the AdobePS printer driver and PPD are installed and
configured, you need to do one of the following:
Windows 95 or 98—to verify that printer interfaces are properly
configured, see “Configuring the Printer” later in this chapter.
Windows NT 4.X—to set up your printer for TCP/IP or AppleTalk,
continue to either “LPR Port Setup for TCP/IP” or “AppleTalk Setup
for EtherTalk” in chapter 5.
Configuring the Printer
If necessary, configure the printer’s communication interface using
the front panel.
1. Select the
SETUP:I/F
menu.
2. Select the menu for the printer interface connected to your
computer (
RS232, PARALLEL, LPR, NETBEUI
or
NVL
PSRV
).
3. Select the
ENABLE
menu. Then, select
YES
.
4. Press the Reset key until
READY/IDLE
displays.
See “Interface Control” in chapter 6 about using the Interface
configuration menus, chapter 5 about configuring the Ethernet
options, and “XANTÉ Command Center” later in this chapter about
configuring communication for that utility.