wsm ME8200, Workshop Manual

Page: 519 / 543

10-S28
ME8200, ME9000, WSM CABIN
Preparation 6
1. Disconnect the differential lock rods (1) and (5).
2. Disconnect the position control rod (2) and draft control rod (4).
3. Disconnect the auxiliary control valve wire (3).
4. Disconnect the PTO wire (6).
(When reassembling)
• Be sure to adjust the position rod length A and draft rod length B.
W1020816
Preparation 7
1. Remove the hose clamps (2).
2. Disconnect the low pressure pipe (4) from compressor and cap
the open fittings immediately to keep moisture out of the system.
3. Disconnect the high pressure pipe 2 (1) from receiver and cap the
open fittings immediately to keep moisture out of the system.
4. Remove the cap stay (3).
(When reassembling)
• Apply compressor oil (DENSO CO. ND-OIL8) to the O-rings and
take care not to damage them.
W1021112
Position rod length A Factory spec.
Approx. 264 mm
10.39 in.
Draft rod length B Factory spec.
Approx. 264 mm
10.39 in.
(1) Differential Lock Rod (Front)
(2) Position Control Rod
(3) Auxiliary Control Valve Wire (4) Draft Control Rod
(5) Differential Lock Rod (Rear)
(6) PTO Wire
Tightening torque
High pressure pipe 2
retaining nut
11.8 to 14.7 N·m
1.2 to 1.5 kgf·m
8.7 to 10.8 lbf·ft
Low pressure pipe
mounting screw
7.8 to 11.8 N·m
0.8 to 1.2 kgf·m
5.8 to 8.7 lbf·ft
(1) High Pressure Pipe 2
(2) Hose Clamp (3) Cap Stay
(4) Low Pressure Pipe
KiSC issued 03, 2007 A