wsm ME8200, Workshop Manual

Page: 200 / 543

2-S18
ME8200, ME9000, WSM CLUTCH
Speed Change Base
1. Remove the lever grip (1).
2. Remove the cover 1 (2) and cover 2 (3).
3. Disconnect the select wire (7) from the base (8).
4. Remove the main speed change rod 1 (6).
5. Disconnect the control wire (4), (5) for auxiliary control valve.
6. Remove the speed change base (8).
(When reassembling)
• Install the control wire (5) of first valve (lower side) into the rear
side slot.
• Execute the following “Adjusting of Select Wire” and
“Adjusting of Control Wire for Auxiliary Control Valve”.
W1020004
(Adjusting of Select Wire)
1. Screw in the wire (2) fully to the rod end (1).
2. Fix the wire (2) so that the threaded portion A and B become the
same.
3. Disconnect the wire (2) from the select lever (3) once.
4. Shift the main speed change lever (7) to the 1st-2nd side until the
lever touches stopper (6), then shift the select lever (3) to the 1st-
2nd side.
5. Check that the hole (5) of the wire end is corresponding to the
projection on the select lever (3).
6. If not, adjust by the nut (4).
7. Reconnect the select wire (2) to the select lever (3).
W1020565
Length of main speed
change rod 1 (L)
Factory spec.
457 mm
17.99 in.
(1) Lever Grip
(2) Cover 1
(3) Cover 2
(4) Control Wire (5) Control Wire
(6) Main Speed Change Rod 1
(7) Select Wire
(8) Speed Change Base
(1) Rod End
(2) Select Wire
(3) Select Lever
(4) Nut (5) Hole
(6) Stopper
(7) Main Speed Change Lever
KiSC issued 03, 2007 A