wsm ME8200, Workshop Manual

Page: 422 / 543

8-S51
ME8200, ME9000, WSM HYDRAULIC SYSTEM
Position and Draft Linkage
1. Remove the clevis pin (2).
2. Remove the circlip (3), (4), (5), (6).
3. Remove the stopper (19) and draw out the rod (3).
4. Remove the stopper (19) and draw out the rod (8). To remove
the O-ring (22) and (23) order by c
→
b
→
a as shown in figure.
5. Remove the cotter pin (21).
6. Take out the linkage.
7. Remove the bracket guide assembly (20).
(When reassembling)
• When install the rods, noting O-ring.
• Apply transmission oil to the O-ring.
• When installing the rod (8), a
→
b
→
c let the fix position of O-
ring (22) go to the outside of the hydraulic cylinder body (25) with
the process alternately, and O-ring (24) is assembled into the
rod. (As shown in figure.)
• When assemble the position connector (10) notched section (18)
upward (It is upward the condition that it is attached to the
tractor).
W1036290
Tightening torque
Bracket guide mounting
screw
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 lbf·ft
(1) Clevis Pin
(2) Clevis Pin
(3) Rod
(4) Circlip
(5) Circlip
(6) Circlip
(7) Circlip
(8) Rod
(9) Spool Retainer
(10) Position Connector
(11) Draft Link 1
(12) Draft Link 2
(13) Position Balancer
(14) Draft Cam
(15) Connector
(16) Feed Back Link
(17) Holder Assembly
(18) Notched Section
(19) Stopper
(20) Bracket Guide
(21) Cotter Pin
(22) O-ring
(23) Chamfer
(24) O-ring
(25) Hydraulic Cylinder Body
(26) Stopper
(27) Screw
KiSC issued 03, 2007 A