wsm ME8200, Workshop Manual

Page: 35 / 543

G-16
ME8200, ME9000, WSM G GENERAL
Replacing Hydraulic Oil Filter
CAUTION
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the drain plug at the bottom of the transmission case
and drain the oil completely into the oil pan.
2. After draining reinstall the drain plug.
3. Remove the two oil filters (1).
4. Clean off metal fillings with clean rags at the magnetic filters (2).
5. Put a film of clean transmission fluid on rubber seal of new filters.
6. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand and additional 1/2 turn only.
7. After the new filter has been replaced, fill with the oil up to the
upper notch on the dipstick (3).
8. After running the engine for a few minutes, stop it and check the
oil level again, add oil to the prescribed level.
9. Make sure that the transmission fluid doesn't leak through the
seal.
IMPORTANT
■
• To prevent serious damage to the hydraulic system, use
only a KUBOTA genuine filter.
W1037606
Changing Transmission Fluid
CAUTION
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. To drain the used oil, remove the drain plug (1) at the bottom of
the transmission case and drain the oil completely into the oil
pan.
2. After draining reinstall the drain plug.
3. Fill with the new KUBOTA SUPER UDT fluid up to the upper
notch on the dipstick (2).
Refer to “LUBRICANTS, FUEL AND COOLANT”. (See page
G-8.)
4. After running the engine for a few minutes, stop it and check the
oil level again; add oil to prescribed level.
W1037968
(1) Hydraulic Oil Filter
(2) Magnetic Filter (Clean off Metal
Fillings)
(3) Dipstick
(4) Oil Filling Plug
A : Oil level is acceptable within this
range.
Transmission fluid Capacity
55.0 L
58.1 U.S.qts
48.4 Imp.qts
(1) Drain Plug
(2) Dipstick
(3) Oil Inlet A : Oil level is acceptable within the
range.
KiSC issued 03, 2007 A