4-S4
L2800, L3400, WSM
REAR AXLE
ROPS
1. Remove the ROPS upper frame (1).
2. Remove the ROPS lower frame (2).
(When reassembling)
W1012666
Rear Wheel and Fender
1. Place the disassembling stand under the transmission case.
2. Loosen and remove the rear wheel mounting screws and nuts.
3. Remove the rear wheel (2).
4. Remove the rear wheel fender (1).
5. Follow the same procedure as above for the other side.
(When reassembling)
W1011172
Rear Axle Case
1. Loosen and remove the rear axle case mounting screws and
nuts.
2. Support the rear axle case (1) with the nylon lift strap and hoist.
3. Separate the rear axle case from brake case.
4. Follow the same procedure as above for the other side.
(When reassembling)
• Apply liquid gasket (Three Bond 1208D, 1141 or equivalent) to
joint face of the rear axle case and brake case, after eliminating
the water, oil and stuck liquid gasket.
W1012958
Tightening torque
ROPS mounting screw
167 to 196 N·m
17.0 to 20.0 kgf·m
123 to 144 ft-lbs
ROPS fulcrum screw
118 to 137 N·m
12 to 14 kgf·m
87 to 101 ft-lbs
(1) ROPS Upper Frame
(2) ROPS Lower Frame
(3) ROPS Fulcrum Screw
Tightening torque
Rear wheel mounting
screw and nut
197 to 226 N·m
20 to 23 kgf·m
145 to 166 ft-lbs
(1) Rear Fender
(2) Rear Wheel
Tightening torque
Rear axle case
mounting screws and
nuts
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
Rear axle case
mounting stud bolt
24.5 to 31.4 N·m
2.5 to 3.2 kgf·m
18.1 to 23.1 ft-lbs
(1) Rear Axle Case
KiSC issued 08, 2007 A
Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
