H3-S11
L2800, L3400, WSM
TRANSMISSION (HST TYPE)
Adjusting HST Pedal and Stopper Bolt
NOTE
■
• Stop the engine when adjusting the cruise control linkage
and pedal stroke.
• Be sure to adjust the HST neutral position (See page H3-
S10.).
1. Adjust the height (B) and (C) of the pedal stopper bolt (3), (4).
2. Loosen the HST pedal mounting screws (2).
3. Set the cruise control lever to fully forward.
4. Tighten the HST pedal mounting screws (2) so that the clearance
(A) between HST pedal and stopper bolt (3) may become 10 to
15 mm (0.39 to 0.59 in.).
W1037923
Adjusting Cruise Control Release Linkage
1. Adjust the brake pedals play first.
2. Depress one of the brake pedals to make sure the cruise control
is not released. Also depress both the brake pedals coupled
together to make sure that the cruise control is released.
3. If the cruise control does not work as above adjust with release
wire (1) as follows.
• Check to see that the threaded portion of the wire (1) rear side is
set at the center position. If not, set by lock nuts (2).
4. In the end of the play of the brake pedal, adjust the lock nuts (3)
so that slack of the wire may become 0.
• Confirm whether to move as above-mentioned 2.
If not, adjust by lock nut (3).
W1038922
Clearance (A)
Factory spec.
10 to 15 mm
0.39 to 0.59 in.
Height (B)
15 mm
0.59 in.
Height (C)
20 mm
0.78 in.
(1) HST Pedal
(2) Screws
(3) Stopper Bolt (Forward)
(4) Stopper Bolt (Reverse)
(1) Release Wire
(2) Lock Nut (Rear)
(3) Lock Nut (Front)
KiSC issued 08, 2007 A
Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
