G-14
L2800, L3400, WSM
G GENERAL
[2] CHECK POINTS OF INITIAL 50 HOURS
Changing Engine Oil
CAUTION
• Before changing oil, be sure to stop the engine.
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. To drain the used oil, remove the drain plug (1) at the bottom of
the engine and drain the oil completely.
4. Screw in the drain plug (1).
5. Fill new oil up to upper line on the dipstick (3).
IMPORTANT
■
• When using an oil of different manufacture or viscosity from
the previous one, remove all of the old oil.
• Never mix two different types of oil.
• Use the proper SAE Engine Oil according to ambient
temperatures.
• Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-7.)
W1014533
Replacing Engine Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before changing oil filter
cartridge (1).
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the engine oil filter cartridge (1).
2. Put a film of clean engine oil on rubber seal of new filter.
3. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil normally
decreases a little. Make sure that the engine oil does not leak
through the seal and be sure to check the oil level on the dipstick.
Then, replenish the engine oil up to the prescribed level.
IMPORTANT
■
• To prevent serious damage to the engine, replacement
element must be highly efficient. Use only a KUBOTA
genuine filter.
W1014892
Engine oil
Capacity
5.7 L
6.0 U.S.qts
5.0 Imp.qts
(1) Drain Plug
(2) Oil Inlet Plug
(3) Dipstick
A : Oil level is acceptable within this
range.
(1) Engine Oil Filter Cartridge
KiSC issued 08, 2007 A
Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
