7. Setting of parameters
105466
– TW-31-E - V1.9 - 06.04.2021
Page 41
7.
Setting of parameters
7.1 GUIDELINE for the correct parameterization
Basically the following has to be specified prior to parameteriza-
tion:
Which signals are available for the detection of the operation mode? See section
4.5 - Connection of external signal transmitters and sensors
How to perform the agitator monitoring. See section 8.12.
Which other system components are to be monitored.
- Float switch detergent container
- Level monitoring in rinsing line
- Thermo protection compressor
Is a detection for the milk feed required? See section 8.2.
If available: Parameterization of the optional Email or SMS module.
Step 1
Connect all hardware components according to wiring diagram.
Optional: Connect EMAIL or SMS modem.
Step 2
Check if all components are wired correctly. See section 7.9
Step 3
Parameterize detection of operation mode: Parameter [h1-h6]
Step 4
Configurate A-parameters -> Hardware
Configurate H-parameters -> extended tank monitor parameters
Configurate h-parameters -> general parameters
Step 5
If necessary assign messages to the various alarms in the F-param-
eters (alarm horn, LED-display, EMAIL or SMS-messages etc.)
7.1.1 Enter customer and tank number
When reading out the tank monitor data on a USB stick, the tank monitor automati-
cally defines the file name of the data file:
DATA-000.CSV
If this file name is already on the stick, the next higher number is used:
DATA-001.CSV
In order to be able to assign the file to the corresponding customer when the files
are later evaluated by Welba-KONSOFT, it is important to enter the customer and
tank number when installing the tank monitor. This is done using the parameters
[h93 + h94] and [h96 + h97].
In this way, the corresponding customer or tank can be assigned to each file.
Also note the 'readout period' specified in parameter [h90]!
Store the parameterization of the TW-31 with the KONSOFT. In this case, you can
reload the correct parameterization to the new device in the case of a spare parts
delivery. Only the actual value correction has to be entered newly.
NOTICE
