Notice
Date
Page
01201055
INSTRUCTION
HANDBOOK
1100
66
11
11. Machine
operation
Reset to zero
Menu line showing
actual weight
2
Weight display mode
Normal mode
3651
3
4775
RUN A WASH PROGRAM
GO TO THE MENU
CLARUS CONTROL
Fig.
2
Fig.
3
After a power-cut
When the supply is restored after a power-
cut, the weight display will show "0" if the
load inside the drum is less than 6.25 kg. If
the load weighs more than 6.25 kg, the true
weight of the load will be shown.
Water level reduction
To achieve optimum load volumes, the
weight of the load can be seen on the dis-
play while the machine is being loaded. If
the machine does not have a full load, the
water level will be reduced according to a
water-level reduction table. The water level
can never be any lower than the safety level
plus the hysteresis.
Actual weight display
The Clarus control unit automatically detects
if weighing equipment is connected, and the
actual (current) weight is shown on the
display, on one line of the menu (normal
display mode).
When the machine starts to be loaded, the
display switches to showing the actual
weight in large numerals (weight display
mode).
Normal display mode is resumed :
•
If a new program number is entered using
the numeric keys.
•
If
is pressed.
•
Automatically after the time set via
"Settings 1" under "Time for weight
display".
While a wash program is running, you can
switch to weight display mode by selecting
"Show weight", see the section "Show
weight" under "Machine operation".
The weight shown on the display will always
be the net weight (achieved because the
weighing equipment has been "tared"). A
slight delay is built in to prevent the display
from flickering.
