– Enter following access code:
● Access code: 18711
– Confirm access code.
– Press
←
button 3 times to go back to diagnosis function
menu.
– Select diagnosis function “14-Long adaptation”.
– Select “Adaptation channel 16”.
– Press
Keyboard
field.
– Using the on-screen keyboard, enter the value 1.
– Press
←
button.
– Press
Confirm
button to reset the learnt value.
– Exit diagnosis function.
– Switch ignition off, and after 60 seconds switch it on again.
– Select “Display group 108” “011-Read measured value
block”.
Indicated on display:
– Check whether the adaptation value for the ash deposit
mass which has been set beforehand is “0”.
– Switch off ignition.
– Adapt exhaust gas pressure sensor 1 -G450-.
3.10 Checking diesel particulate filter, en-
gine codes CJDA, CJDD
Note
◆
If the diesel particulate filter is renewed, the adaptation value
for the ash deposit mass must be set to “0”, renew diesel
particulate filter.
◆
If the engine control unit has been renewed, the adaptation
value for the ash deposit mass must be set to the adaptation
value which has been read before.
Test prerequisites
● Fuses must be OK.
● The battery voltage must be at least 11.5 V.
● All electrical consumers must be switched off.
● Earth connections OK
● No fault entry in event memory
, read event mem-
ory.
Test procedure
Reading mileage since last regeneration
– Switch ignition on.
Display group 108
xxx ml 0.0 g 0.0 g
3
Industriemotoren - Industrial Engines 2009
▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
460
Repair Group 26 - Exhaust system
