VMware VS4-ENT-PL-A - vSphere Enterprise Plus, Setup Manual

Page: 207 / 276

Package Warning Message When You Assign an Image Profile to Auto Deploy
Host
When you run a PowerCLI cmdlet that assigns an image profile that is not Auto Deploy ready, a warning
message appears.
Problem
When you write or modify rules to assign an image profile to one or more hosts, the following error results:
Warning: Image Profile <name-here> contains one or more software packages that are not stateless-
ready. You may experience problems when using this profile with Auto Deploy.
Cause
Each VIB in an image profile has a
stateless-ready
flag that indicates that the VIB is meant for use with
Auto Deploy. You get the error if you attempt to write an Auto Deploy rule that uses an image profile in
which one or more VIBs have that flag set to FALSE.
N
OTE
You can use hosts provisioned with Auto Deploy that include VIBs that are not stateless ready
without problems. However booting with an image profile that includes VIBs that are not stateless ready is
treated like a fresh install. Each time you boot the host, you lose any configuration data that would
otherwise be available across reboots for hosts provisioned with Auto Deploy.
Solution
1 Use Image Builder PowerCLI cmdlets to view the VIBs in the image profile.
2 Remove any VIBs that are not stateless-ready.
3 Rerun the Auto Deploy PowerCLI cmdlet.
Auto Deploy Host Reboots After Five Minutes
An Auto Deploy host boots and displays iPXE information, but reboots after five minutes.
Problem
A host to be provisioned with Auto Deploy boots from iPXE and displays iPXE information on the console.
However, after five minutes, the host displays the following message to the console and reboots.
This host is attempting to network-boot using VMware
AutoDeploy. However, there is no ESXi image associated with this host.
Details: No rules containing an Image Profile match this
host. You can create a rule with the New-DeployRule PowerCLI cmdlet
and add it to the rule set with Add-DeployRule or Set-DeployRuleSet.
The rule should have a pattern that matches one or more of the attributes
listed below.
The host might also display the following details:
Details: This host has been added to VC, but no Image Profile
is associated with it. You can use Apply-ESXImageProfile in the
PowerCLI to associate an Image Profile with this host.
Alternatively, you can reevaluate the rules for this host with the
Test-DeployRuleSetCompliance and Repair-DeployRuleSetCompliance cmdlets.
The console then displays the host's machine attributes including vendor, serial number, IP address, and so
on.
Chapter 7 Installing ESXi
VMware, Inc. 207