VMware VS4-ENT-PL-A - vSphere Enterprise Plus, Setup Manual

Page: 206 / 276

Cause
After the host has been added to a vCenter Server system, the boot configuration is determined by the
vCenter Server system. The vCenter Server system associates an image profile, host profile, or folder
location with the host.
Solution
u
Use the
Test-DeployRuleSetCompliance
and
Repair-DeployRuleSetCompliance
PowerCLI cmdlets to
reevalute the rules and to associate the correct image profile, host profile, or folder location with the
host.
Host Is Not Redirected to Auto Deploy Server
During boot, a host that you want to provision with Auto Deploy loads iPXE. The host is not redirected to
the Auto Deploy server.
Problem
During boot, a host that you want to provision with Auto Deploy loads iPXE. The host is not redirected to
the AutoDeploy server.
Cause
The
tramp
file that is included in the TFTP ZIP file has the wrong IP address for the Auto Deploy server.
Solution
u
Correct the IP address of the Auto Deploy server in the
tramp
file, as explained in the vSphere Installation
and Setup documentation.
Auto Deploy Host with a Built-In USB Flash Drive Does Not Send Coredumps to
Local Disk
If your Auto Deploy host has a built-in USB flash drive, and an error results in a coredump, the coredump is
lost. Set up your system to use ESXi Dump Collector to store coredumps on a networked host.
Problem
If your Auto Deploy host has a built-in USB Flash, and if it encounters an error that results in a coredump,
the coredump is not sent to the local disk.
Solution
1 Install ESXi Dump Collector on a system of your choice.
ESXi Dump Collector is included with the vCenter Server installer.
2 Use ESXCLI to configure the host to use ESXi Dump Collector.
esxcli conn_options system coredump network set IP-addr,port
esxcli system coredump network set -e true
3 Use ESXCLI to disable local coredump partitions.
esxcli conn_options system coredump partition set -e false
vSphere Installation and Setup
206 VMware, Inc.