Vitalcare 506DN3, Service Manual

Page: 134 / 254

Section 7 —Disassembly
Page 7-22 VitalCare
TM
506N3 Series Service Manual Criticare Systems, Inc.
Front Bezel Service
Disassemble Front Bezel
from Rear Housing
1. Follow the caution for static-sensitive devices in “Electrostatic
Discharge Protection” in this section.
2. Turn the monitor off and disconnect the monitor from the AC
(Mains) power source.
3. Remove the battery as described in “Battery Removal/
Replacement” in Section 5.
4. Flip the unit over and loosen the four (4) gray-coated screws
(pn 40195B005). There are two (2) screws at the top of the
handle and two (2) screws at the bottom of the rear housing.
Torque is 5 in. lbs.
Figure 7-28: Remove Screws Holding Bezel
5. Carefully pull the front bezel away from the rear housing.
6. Disconnect the remaining cables from the main board.
NOTE : Inserting cables incorrectly during reassembly will cause
damage.
Figure 7-29: Disconnect Cables
Remove Screws
Printer Cable
NIBP Cable
SpO
2
Cable
Battery Cable
AC Cable
Temp Cable