Vitalcare 506DN3, Service Manual

Page: 42 / 254

Section 2 —Service Menus
Page 2-10 VitalCare
TM
506N3 Series Service Manual Criticare Systems, Inc.
Trend Menu
NOTE : The Trend menu is accessed by pressing the TREND key
located on the front panel.
Patient Menu
User Defaults
This is a default setting profile that can be set for a facility’s special
needs. The settings are located in a protected menu to inhibit
unauthorized changes to the
USER defaults settings.The user
defaults are initially set to the same settings as the HOSP (hospital)
defaults. User defaults setup should be performed by qualified
personnel.
Setting User Defaults
A facility can save settings in a USER default setting. Once the
settings are made, the settings can be saved under a USER setting
profile on the monitor.
To set settings different from the HOSP (hospital) defaults:
1. Power up the monitor. Wait for the screen to display PATIENT .
2. Press the PATIENT key to set the settings for each patient size.
3. Press the MENU key.
4. Adjust the settings in ALARM MENU , PARAMETER SETUP , and
CONFIGURATION for each patient size.
NOTE : It is not possible to store USER defaults for LOW
SPO2 <85%, NIBP ON/OFF , SPO2 ON/OFF , TEMP ON/OFF ,
TEMP MODE , and LANGUAGE . Each of the ignored user
defaults is controlled independently of the USER default
settings. LOW SPO2 returns to a default value of 85% if the
current setting is below 85%.
5. Verify all settings are set correctly.
Setting Options
Factory Default
Value
Trend Int. 1, 2, 5, 10, 15, 30, 60 minutes, Off 15 minutes
Trend Format BPT, BP, Last, No BPT, All BPT
Trend Span 10, 15, 30, 60 minutes 2, 4, 8, 12, 24 hours, All 4 hours
Setting Options Factory Default Value
Mode Adult, Pediatric, Neonatal Adult