Videonics MXPro DV, User Manual

Page: 44 / 198

MXP
RO
DV U
SER
G
UIDE
C
HAPTER
3 36
Post Production Configuration
The configuration described in this section is useful in a Post-Production environ-
ment—where you mix two or more programs together.
This installation example shows the use of DV equipment in combination with ana-
log equipment.
1 Connect the Output from a DV VCR to DV IN 1 on the MXProDV rear panel.
2 Connect the Output from a DV Camcorder to DV IN 2 on the MXProDV rear panel.
3 Connect a Composite-type monitor to the PREVIEW OUT jack on the rear panel.
4 Connect a DV recording VCR to the DV OUT jack on the rear panel.
5 Connect an Output Monitor to the recording VCR so you can see the signal being
recorded.
6 OPTIONAL – Connect an audio source (CD player, tape deck, or microphone) to
AUDIO IN 4 on the MXProDV rear panel.
7 Connect the power cord and transformer to the MXProDV rear panel. See “Power
Connector” on page 31 for instructions.
Use the Route function (“Route” beginning on page 92) to make sure your devices
are directed to the correct MXProDV channels.