SD500 Spindle Servo Drive Manual
22
Chapter 4 Parameter Table
4.1 Parameter Mark Description
Marks and terms indicating control modes
Mark
Content
V/F
Valid parameters in V/F control mode for asynchronous motors
SVC
Valid parameters under open-loop vector control of asynchronous motors
FVC
Valid parameters under closed-loop vector control of asynchronous motors
PMVF
Valid parameters in V/F control mode for synchronous motors
PMSVC
Valid parameters in open-loop vector control mode for synchronous motors
PMFVC
Valid parameters in closed-loop vector control mode for synchronous motors
Table 4-1
Note: The control mode marks not shaded indicate that the parameters are not valid in that control mode.
Marks and terms indicating control modes
Mark
Content
RUN
Parameters that can be modified during running
STOP
Parameters that cannot be modified during running
READ
The parameter can only be read, not modified (LED shows 5 "--" when modified)
Table 4-2
4.2 Parameter List
Parameters types of this product
Parameter
Designation
Parameter
Designation
F00.0x
Environment settings
F06.2x-F06.3x
Digital, relay output
F01.0x
Basic command
F06.4x
Frequency detection
F01.1x
Frequency command
F06.5x
Monitor parameter comparator output
F01.2x-F01.3x
Acceleration/deceleration time
F06.6x
Virtual input/output terminal
F01.4x
PWM control
F07.0x
Start control
F02.0x
Motor basic parameters and self-learning selection
F07.1x
Stop control
F02.1x
Advanced parameters of asynchronous motors
F07.2x
DC braking and speed tracking
F02.2x
Advanced parameters of synchronous motors
F07.3x
Jogging
F02.3x-F02.4x
Encoder parameter
F07.4x
Start/stop frequency holding and hopping
F02.5x-F02.60
Motor application parameter
F10.0x
Current protection
F02.6x-F02.7x
Sine-cosine encoder parameter
F10.1x
Voltage protection
F03.0x
Speed loop
F10.2x
Auxiliary protection
F03.1x
Current loop and torque limit
F10.3x
Load protection