Page 2:
#of Streams:
From 1 to 10 streams.
# of Streams can be specified either on Page 1 or Page 2. It will be reflected on both pages.
Delay Measurement Mode:
Disable, Round Trip Delay. Local One way delay measurement, Atomic one way delay, or GPS
one way delay are also available depending on the Clock Synchronization device selected in the
Setup (home menu) >
Measurement
menu. Refer to
for more information. Round Trip Delay should only be enabled when
running the test to a remote loopback.
Histogram:
Enable / Disable
Sampling Period:
1sec, 10secs, 30secs, 1min, 10min, 30min, 1hr. Defines how often the RTD (round trip delay)
measurement is evaluated against the RTD threshold.
Threshold (Max RTD allowed):
Input the value in us, ms or sec. Defines the maximum allowed round trip delay value. If the
RTD value exceeds the threshold, an event is logged with corresponding time stamp.
SDT Measurement
: Enable/Disable. The Service Disruption Test is triggered based on user established thresholds.
SDT Measurement Trigger (>us)
: Any inter-frame gap that is equivalent or greater than the configured threshold will
trigger the SDT measurement. This is useful if a known threshold is expected from a given network under test. For
example, if the known switchover time is 50ms, the trigger can be set to a value slightly below 50ms to assure that the
SDT is measured.
SDT Violation Threshold (us)
:Triggers an SDT Violation event in the event log. This is helpful for historical purposes
during any given test. If the measured SDT is equivalent or greater than the configured threshold an SDT Violation
event is counted.
Traffic Loss Trigger:
If the receiver does not detect incoming traffic within the configured threshold time, a traffic loss trigger
is recorded in the event log.
RTD Unit Auto Scale:
On/OFF
Throughput Setup - General Settings
(Page 2)
RXT-6400_Module_Manual
Page 66 of 119
