Latency tab:
User configures the following:
Test:
Throughput Rate or Custom Rate. The default value is throughput.
Throughput rate
: Latency test will be performed at the throughput rate found for each of the tested frame sizes.
Custom rate:
User configures a custom rate in % or Mbps.
Custom Rate per frame size:
The user can configure a custom rate in % or Mbps for each test frame. Tap on
Rate
Table Config
. to configure rates for each frame. After making edits tap
Apply
to confirm edits or
Apply to All
to apply
rates to all tests.
Rate:
Only available if Custom Rate is selected. Enter up to 100% of the negotiated line rate or enter the rate in Mbps.
Duration:
5 to 999 seconds. The default value is 20 seconds.
This is the amount of time that the latency test will be performed for each test frame size.
Repetitions:
1 to 100. The default value is 1.
This is the amount of times that the latency test will be repeated for each test frame size.
RFC 2544 Setup - Latency Settings
Frame Loss tab:
Max Rate:
Up to 100% of the negotiated line rate. The default value is 100%.
This is the maximum transmit rate to perform the frame loss test for each test frame size. The user may configure this rate as
a % of the total line rate or in Mbps. For example if the user configures the Max Rate to be 90% and the negotiated line rate
RXT-6400_Module_Manual
Page 42 of 119
