Veeco MPS-3000 CE, Technical Manual

Page: 26 / 96

22
On - In the on position, the emission current will track the beam cur-
rent at 200%.
Off - In the off position, the emission current will track the beam current
at 125%.
SW1-8:
On - In the on position, the front panel will remain locked following a
power cycle if it was locked with the serial communication command
NK1.
Off - In the off position. The front panel will be unlocked following a
power cycle.
All switches will be factory-set. The SW1-1 switch is for factory use only and
should never be changed.
Switch Settings for Switch Bank #2
SW2-1:
Not used.
SW2-2:
Controller Board Alarm Switch
On - In the on position, the controller board alarm will sound when a
Fatal error has been detected and will sound at power-up of the unit.
Off - In the off position, the controller board alarm will not sound when
a Fatal error has been detected or at unit power-up.
All switches will be factory-set. The SW1-1 switch is for factory use only
should never be changed.
Table 4.3: Factory Switch Settings For Switch Bank #1
SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8
Off Off Off Off On Off Off Off
Table 4.4: Factory Switch Settings For Switch Bank #2
SW1 SW2
Off On
NOTE
NOTE