Instruction Sheet
Part 1107150-02
E
2020 Nordson Corporation
P/N 1107150-02
Standard iControl
r
Power Supply Kit
This instruction sheet is a guide for upgrading to the Standard iControl
Power Supply.
WARNING:
Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Removing Old Power Supply
WARNING:
Turn all power off to the system before performing any
procedures.
1. Cut any cableties away from the AC power harness (8) and DC power
harness (4).
2. Disconnect the AC power harness (8) from the terminal block (9).
3. Disconnect the DC power harness (4) by disconnecting at the P1 header
(2) on the back plane (1).
4. Disconnect the digital flow connections (3) from the power supply
terminals (5A and 5B).
5. Support the power supply bracket (11) while removing the M4 x 12
screws (12) and save these screws for installation of the new power
supply.
6. Remove the bracket (11), power supply (10), along with the DC and AC
harness (4, 8) from the sub-panel.
