Climate control
83
1 : time setting
2 : heating indicator
3 : time display
4 : ventilation indicator
5 : set
6 : preset numbers
7 : timer indicator
8 : immediate heating
Setting system clock time
Set the clock of the parking heater
before setting up time presets for
heating.
● Press and hold set. The display
and the timer indicator will come
on.
● Within 10 seconds, while still
holding set, press
P
or
Q
to
decrease or increase hours until
correct time is displayed. Press
and hold
P
or
Q
to decrease or
increase hours faster.
● Release set.
When the display switches off, the
time is stored.
Display time
Press
P
or
Q
.
Timer indicator will come on and the
time will be displayed for approx. ten
seconds.
Immediate start of heating system
● Before turning on the heating,
check that in the centre console
temperature is set to warm / high
and air flow control knob is in
position two.
● Press button for immediate
heating (8) to start heating.
The display and the heating indicator
will come on and stay on for the entire
operating time.
Preset start of heating
The start time can be preset between
1 minute and 24 hours in advance. Up
to three different start times can be
stored, but only a single preset start
can be programmed.
To perform a daily start at a fixed time,
reprogramme the stored time each
day.
● Press set. The display will switch
on.
--:-- or the previous stored time
and corresponding preset
number (1, 2 or 3) are displayed
for 10 seconds.
To recall other preset times,
press set several times before
the end of the 10 seconds.
● Within 10 seconds, press
P
or
Q
to select the desired start time.
When the new preset time is stored
display of start time and preset
number will disappear and display
lighting will switch off.
By default, preset times are already
stored in the system (1 = 06:00, 2 =
16:00, 3 = 22:00). Any change
