Vatech A9 (PHT-30CSS)
Technical manual
VDH-TeM-098
196 / 214
COPYRIGHT© 2020 VATECH
.
ALL RIGHTS RESERVED
Command
Remark
[SMP_ECHK_0002]
At the end of abnormal shooting by releasing the irradiation
switch, Messages sent before [SMP_STOP_0000]-Purpose
of identifying the cause of the outage
[SMP_CPOF]
This command is to turn off the power of the sensor and
notify it when there is no command input for 30 minutes.
[SPM_STIT_0000]
Xxxx captures in CT stitching mode
PANO mode sensor reference position setting command
[SPM_PMCT_0000]
[SPM_CMCT_0000]
CT mode sensor reference position setting command
[SPM_CSMV_0000]
The command for setting collimator drive amount between
the inner circle and outer circle during CT mode capture
[SPM_CCMV_0000]
The command for setting collimator drive amount between
the inner circle and outer circle during CT mode capture
[SPM_PSCR_0000]
PANO mode sensor, collimator drive frequency ration setting
[SPM_CSCR_0000]
CEPH mode sensor, collimator drive frequency ration setting
[SPM_CPIO_0000]
PANO mode collimator’s capture initial position offset setting
[SPM_CHP?]
Command to check chin rest position
[SPM_XRES]
X-ray remote exposure start
[SPM_XREE]
X-ray remote exposure end
[SPM_XRET]
X-ray remote exposure time set (ex) 0500 = 5 sec
[SPM_XREH]
X-ray remote exposure halt
[SPM_LONV]
Vertical beam on
[SPM_LOFV]:
Vertical beam off
