Vatech A9 (PHT-30CSS)
Technical manual
VDH-TeM-098
197 / 214
COPYRIGHT© 2020 VATECH
.
ALL RIGHTS RESERVED
3.
Procedure for using remote exposure function
•
To use the remote exposure function for the first time, approval and
login of the hospital personnel are required.
•
Do not use the remote exposure function when exposure a patient.
•
Before using the remote exposure function, check with the hospital
personnel to make sure there are no people around the equipment/X-ray
room, and use this function.
3.1. When exposure the PANO/CEPH in Console Software
1. Run the Console Software.
2. Open the command input window with the
Ctrl + S
key.
3. Send the [SPM_XRES] command to activate the remote exposure mode.
4. Set the mode (PANO/CEPH) in the Console Software.
5. Click the
Confirm
button and
Ready
button in the Console Software.
6. Automatically start the exposure 3 seconds after the Dark acquisition.
3.2. Remote exposure sequence when acquiring the Bright Calibration
1. Open the VAKCAP.exe file of the applicable mode.
2. Move to the Soft Calib Tab.
3. Acquire DARK.
4. Check the DARK is Normal.
5. Send the [SPM_XRES] command to activate remote exposure mode.
6. Send the [SPM_XRET_0500] command to exposure for 5 seconds.
7. Press the
Bright
button to acquire Brightness for each point.
3.3. TUTS Test
1. Run the Terminal or the VAKCAP.exe file.
2. Send the [SPM_XRES] command to activate the remote exposure mode.
3. Use the [SPM_XRET_xxxx] command to set the desired exposure time.
ex) [SPM_XRET_0900] = 9 seconds
4. Input the [SPM_TUTS] command to exposure X-ray for the set time.
5. To stop X-ray exposure before the set exposure time during X-ray exposure, stop with
the [SPM_XREH] command.
3.4.
XTST Test
1. Run the Terminal or the VAKCAP.exe file.
2. Send the [SPM_XRES] command to activate the remote exposure mode.
3. Set and input the desired exposure time using the [SPM_XTST_xxxx] command, X-ray
exposure proceeds for the set time.
