Vacon 20 CP, Installation, Technical And Maintenance Manual

Page: 87 / 112

Options vacon • 84
Service support: find your nearest Vacon service center at www.vacon.com
8
8.4.6 Parameter menu
In Parameter menu only the Quick setup parameter list is shown as default. To view the other ad-
vanced parameter groups, see the Application Manual. The following figure shows the parameter
menu view:
Figure 46.Parameter menu
Change value of a parameter following the procedure below:
1. Locate the parameter.
2. Enter the Edit mode by pressing OK.
3. Set new value with the arrow buttons up/down. You can also move from digit to digit with the
arrow buttons left/right if the value is numerical and change then the value with the arrow but-
tons up/down.
4. Confirm change with OK button or ignore change by returning to previous level with Back/
Reset button.
OK
OK
2
Press Right to browse
otherPar. group
4
Press OK button to enter
edit mode
3
Press down button to
browse P3.4
5
Press Up / Down to change value
OK
6
Press OK to confirm
FA U LT A L A R M S TO P R E A D Y R U N FA U LT A L A R M S TO P R E A D Y R U N
FA U LT A L A R M S TO P R E A D Y R U N
F W D R EV I/O K E Y PA D B U S F W D R EV I/O K EY PA D B U S
F W D R EV I/O K EY PA D B U S
1 Press OK to enter Pa r. menu
FA U LT A L A R M S TO P R E A D Y R U N
F W D R EV I/O K EY PA D B U S
FA U LT A L A R M S TO P R E A D Y R U N
F W D R EV I/O K EY PA D B U S
Hz
SYS / FLT
PAR
REF
MON
SYS / FLT
PAR
REF
MON
SYS / FLT
PAR
REF
MON
SYS / FLT
PAR
REF
MON
SYS / FLT
PAR
REF
MON