Utilimaster Corporation attempts to provide
information that is accurate, complete, and
useful. All information contained in this
manual is based on the latest product infor-
mation available at the time of publication.
However, because of the Utilimaster policy
of continual product improvement, Utilimas-
ter reserves the right to amend the informa-
tion in this document at any time without
prior notice.
This material is confidential and the prop
-
erty of Utilimaster. It is shared with your
company for the sole purpose of helping you
with the operation of the described equip-
ment.
Utilimaster makes no warranty of any kind
with regard to this material, including, but
not limited to, the implied warranties of
merchantability and fitness for a particular
purpose. Utilimaster shall not be liable for
errors contained herein or for incidental or
consequential damages in connection with
the furnishing, performance, or use of this
material.
Utilimaster expressly disclaims all respon-
sibility and liability for the installation, use,
performance, maintenance, and support of
third-party products. Customers are advised
to make their independent evaluation of such
products.
No part of this document may be photo-
copied, reproduced, or translated to another
language without the prior written consent
of Utilimaster.
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
For Assistance Call: 800-237-7806
Visit us at:
www.utilimaster.com
80
Reach—Body Service Manual
E-mail:
Rollers
Removal
1. Open door.
2. Remove nuts that secure the roller retainer.
3. Remove roller from track and set aside.
Installation
1. Insert roller into retainer.
2. Place roller into track.
3. Replace the retainer and tighten the nuts.
4. Lubricate with a light oil (Utilimaster P/N 04202540).
Seals
Brush Seal Removal
1. Open door.
2. Remove rivets.
3.
Use a flat-blade screwdriver to pry apart the crimped
extrusion.
4. Remove seal and discard.
Brush Seal Installation
1.
Test fit brush seal and cut to proper length with bolt
cutters.
2. Crimp the extrusion.
3. Secure seal with
rivets.
Bottom roller bracket
Roller bracket
Brush seal