Utilimaster Corporation attempts to provide
information that is accurate, complete, and
useful. All information contained in this
manual is based on the latest product infor-
mation available at the time of publication.
However, because of the Utilimaster policy
of continual product improvement, Utilimas-
ter reserves the right to amend the informa-
tion in this document at any time without
prior notice.
This material is confidential and the prop
-
erty of Utilimaster. It is shared with your
company for the sole purpose of helping you
with the operation of the described equip-
ment.
Utilimaster makes no warranty of any kind
with regard to this material, including, but
not limited to, the implied warranties of
merchantability and fitness for a particular
purpose. Utilimaster shall not be liable for
errors contained herein or for incidental or
consequential damages in connection with
the furnishing, performance, or use of this
material.
Utilimaster expressly disclaims all respon-
sibility and liability for the installation, use,
performance, maintenance, and support of
third-party products. Customers are advised
to make their independent evaluation of such
products.
No part of this document may be photo-
copied, reproduced, or translated to another
language without the prior written consent
of Utilimaster.
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
75
For Assistance Call: 800-237-7806
Parts On-line:
https://parts.utilimaster.com
Reach—Body Service Manual
Fax: 574-862-7637
Adjustment
NOTE: Adjusting the roller bracket up moves the panel in. Adjusting the roller bracket
down moves the panel out. The door may jam if adjusted too tightly.
1. Check that the door has no more than 1/4" maximum play, does NOT bind in the track, and is
centered in opening.
2.
Add or subtract washers on roller shafts to achieve proper door operation. A maximum of five
spacer washers should be at the second from top roller and the second from bottom roller on each
side. Loosen nuts on top roller bracket.
3. Position top roller brackets so that the top panel is vertical and seals along both the top and sides.
4. Tighten nuts.
See
Nut location on top roller bracket